IO Expansion Shield Xbee Module Sensor Expansion Shield Development Board IIC SPI 3/4pin WIFI-LPT100 Module Interface

Höjdpunkter

• 3-pin & 4-pin sensor interfaces, supports connecting sensors directly without complicate custom connections
• XBee module connector
• WIFI-LPT100 wireless module connector

Specifikation

1. XBee module connector
2. IIC-gränssnitt
3. SPI gränssnitt
4. 3-pin sensor interface
   • VCC : power positive
   • GND : ground
   • D : digital pin, correspond to the Arduino board
5. WIFI-LPT100 connector
6. 4-pin sensor interface
   • VCC : power positive
   • GND : ground
   • A : analog pin, correspond to the Arduino board
   • D : digital pin, correspond to the Arduino board
7. VCC configuration : for selecting sensor interfaces power voltage
8. Debugging/Communication selection jumper
   • when connecting TXD and TX, RXD and RX respectively, the Arduino board may debug/config the XBee module or WIFI-LPT100 through serial port
   • when connecting TXD and RX, RXD and TX respectively, the Arduino board may kommunicera med the XBee module or WIFI-LPT100 through serial port
9. Strömindikator
10. WIFI-LPT100 state indicator
11. XBee module state indicator
12. WIFI-LPT100 RELOAD button : for restoring to factory setting
13. XBee module and WIFI-LPT100 RESET button
14. XBee module EASYLINK Knappen

Vad finns i boxen?

• 1 x IO Expansion Shield